Electrical-Photos.com

Fed-ex

Wirenuts29 — Tue, 27 Jan 2009 22:27:13 +0000

by: Wirenuts29

Description: behind patch panels

fed-ex

Wirenuts29 — Tue, 27 Jan 2009 22:27:11 +0000

by: Wirenuts29

Description: during terminations

3 comments

fed-ex

Wirenuts29 — Tue, 27 Jan 2009 22:27:09 +0000

by: Wirenuts29

Description: most of cat-5 drops pulled

100_0466

Wirenuts29 — Tue, 27 Jan 2009 22:23:10 +0000

by: Wirenuts29

Description: same pipe about 6' away unreal

100_0465

Wirenuts29 — Tue, 27 Jan 2009 22:23:07 +0000

by: Wirenuts29

Description: active fire alarm system, suprisingly no ground faults or shorts, that 1/2" is screwed in 2 spots in less than 2" ! i know where to look if a ground fault ever comes in

100_0370

Wirenuts29 — Tue, 27 Jan 2009 22:23:05 +0000

by: Wirenuts29

Description: Open air splices, vent installed to no where? the romex that went from the switch to the vent 8' away was spliced in 3 spots, and no jb's

maindisco

Wirenuts29 — Mon, 19 Jan 2009 02:19:08 +0000

by: Wirenuts29

Description: This is the replacement tub of the 1200 amp service change we did, notice how tight it fits in that lean to. this thing was a monster to install.

inside ct cab

Wirenuts29 — Mon, 19 Jan 2009 02:19:06 +0000

by: Wirenuts29

Description: this is part of an installation which had a neutral become energized after changing over

emergency notification system

Wirenuts29 — Fri, 16 Jan 2009 04:10:30 +0000

by: Wirenuts29

Description: View of full array, and recieving antena on top of 11' mast.

emergency notification system

Wirenuts29 — Fri, 16 Jan 2009 04:10:28 +0000

by: Wirenuts29

Description: Base and bottom set of 4 speakers, there are 4 more above.

1 comment

emergency notification system

Wirenuts29 — Fri, 16 Jan 2009 04:10:26 +0000

by: Wirenuts29

Description: one of 2 amplification/broadcast stations we installed on campus

conventional fire alarm system upgrade

Wirenuts29 — Fri, 16 Jan 2009 04:03:11 +0000

by: Wirenuts29

Description: new system

conventional fire alarm system upgrade

Wirenuts29 — Fri, 16 Jan 2009 04:03:09 +0000

by: Wirenuts29

Description: new panel. wires being pulled

conventional fire alarm system upgrade

Wirenuts29 — Fri, 16 Jan 2009 04:03:07 +0000

by: Wirenuts29

Description: this is the old fire alarm in this small warehouse notice the 2 60 watt heaters!!

fire alarm upgrade

Wirenuts29 — Fri, 16 Jan 2009 03:59:47 +0000

by: Wirenuts29

Description: This is the relay board within the main facp. Each rlay trips a zone in the kelron radio box above the facp. notice the orange wire. thats protocol in rhode island to trip master boxes or radio boxes.

fire alarm upgrade

Wirenuts29 — Fri, 16 Jan 2009 03:59:44 +0000

by: Wirenuts29

Description: These are 3 sync modules wired within the facp enclusure. they syncronize the three outgoing naccircuits which drive the 10 booster panels throughout this building.

fire alarm upgrade

Wirenuts29 — Fri, 16 Jan 2009 03:59:42 +0000

by: Wirenuts29

Description: This is a pic taken after we relocated the new fire alarm panel, installed one of 10 Nac Boosters, and wired the keltron radio box. This setup was about 6 feet to the left, on a tmporary strut rack while an old system was still in use

Service change 600 amp to 1200

Wirenuts29 — Fri, 16 Jan 2009 03:51:25 +0000

by: Wirenuts29

Description: Photo #1 new C.T. CABIET WITH 800 AMP DISTRIBUTION PANEL. Photo# 2 New tap can to re-feed existing meter stack, notice the label from the factory labeling the bussing as neutral phase a phase b phase c. this caused a huge problem as the existing meter stack was in all actuallity phase a phase b then neutral, then phase c. Bad nws for us!

Service change 600 amp to 1200

Wirenuts29 — Fri, 16 Jan 2009 03:51:23 +0000

Service change 600 amp to 1200

Wirenuts29 — Fri, 16 Jan 2009 03:51:21 +0000